2K Wired Floodlight: Lorex App - Motion Detection Settings

You can enable/disable the following settings from the Motion Detection screen for your 2K Wired Floodlight Camera (W452AS Series):

• Motion Detection
• Person Detection
• Vehicle Detection
• Animal Detection
• Abandoned Object Detection
• Missing Object Detection
• Motion Sensitivity
• Motion Zones™

To enable Motion Detection

1. Launch the Lorex App.

2. Tap icon above the channel thumbnail on the Devices screen.

3. Tap the icon to enable Motion Detection. Tap again to disable.

Note: Motion Detection must be enabled for Smart Motion Detection.

To enable or disable Motion / Person / Vehicle / Animal / Abandoned Object / Missing Object detection

Enabling these detection settings will record video and send notifications when motion, person, vehicle, animal is detected and/or when an object is left behind or an object is taken from the Motion Zone.

Note: Notifications and Motion Detection must be enabled.

1. Launch the Lorex App.

2. Tap the icon above the channel thumbnail on the Devices screen.

3. Tap Motion Detection Settings.

4. Tap the icon to enable Motion/Person/Animal/Vehicle Detection. Tap again to disable.

To change Motion Sensitivity

You can adjust the level of Motion Sensitivity of your Lorex device according to your preference. The higher the sensitivity level, the less motion is required to trigger an event.

Note: Higher sensitivity will result in increased notifications.

1. Launch the Lorex App.

2. Tap the icon above the channel thumbnail on the Devices screen.

3. Tap Motion Detection Settings.

4. Tap Motion Sensitivity.

5. Tap and select the level of Motion Sensitivity, then tap Save.

Configuring Motion Zones™

Motion Zones™ allows you to customize your device’s motion detection region. Areas of the camera image that trigger unwanted motion events can be ignored, such as a busy sidewalk or trees blowing in the wind.

To set Motion Zones™

1. Launch the Lorex App.

2. Tap the icon above the channel thumbnail on the Devices screen.

3. Tap Motion Detection Settings.

4. Tap Motion Zones™.

To set customized Motion Zones™

This setting can only detect motion in the specified area.

By default, the entire area has a blue overlay, meaning that a motion event happening anywhere on the screen will trigger an event.

1. Tap icon to remove the blue overlay from the entire image.

2. Tap and drag over the area where you want motion detection enabled.
   Note: The deselected area will grey out and the selected area will be highlighted in blue.

3. (Optional) Tap icon to exclude any area from the Motion Zones™.

4. (Optional) Tap icon switch the Motion Zones™ to the unselected area.

5. Tap Save.