< Back to list
LNB45ABB, LNB45ABW, Aurora Series - 4MP IP PoE Wired Bullet Camera: Installation Guide
This article gives installation instructions for your LNB45ABB and LNB45ABW 4MP IP PoE Wired Bullet Cameras.
What is included:
- 4MP IP PoE Wired Bullet Camera
- Mounting Template
- Anchors & Screws (4×)
- Weather-resistant Cap
Camera Placement Tips:
- Consider what you want to monitor and find the best area for coverage.
- Place the camera close to the area of interest.
- Avoid placing the camera directly in front of obstructions like trees, bricks, rain gutters, or reflective surfaces.
- Install the camera where it is difficult for thieves and vandals to reach.
- Ensure the mounting surface can support at least 1.5 lbs/0.6 kg (3× the camera’s weight).
- The ideal position is about 10 feet/3 meters above ground, angled 15° downward.
- Secure the cables so they cannot be seen or easily cut.
Installation:
Warning: Ensure the mounting surface supports 3.18 lbs/1.4 kg, 3× the camera’s weight.
- Use the mounting template to mark and drill holes for screws and the camera’s cable.
Note: To route cables along a wall, use the camera’s cable notch.
- Insert anchors for surfaces like drywall, wood, brick, masonry, or concrete.
- Guide the camera’s cable through the surface opening or cable notch.
- Connect one end of the Ethernet cable into the camera’s Ethernet connector and the other end into the NVR’s PoE port.
- Secure the weather-resistant cap by twisting it onto the camera’s Ethernet connector. If exposed to rain, seal it with silicone or electrical tape.
- Attach the camera’s bracket to the surface using the provided screws and a screwdriver.
- Loosen the adjustment screw with a screwdriver to position the camera, then securely tighten it in place.
- Important: Remove the vinyl film from the camera lens for a clear view.