< Back to list
AEX16 Series - 16-Port PoE Switch: Installation Guide
This article gives installation instructions for your AEX16 16-Port PoE Switch.
What's Included:
- PoE Switch
- Power Cord
- Rubber Feet (4×)
- Rack Mount Brackets (2×)
- Screws (8×)
- SFP Dust Cap
Safety Precautions
- Follow all instructions for safe use and best performance.
- Use the switch within given temperature, humidity and voltage levels noted in the switch specifications.
- Do not disassemble the switch.
- You may need to clean periodically using a cloth. If you need to clean the switch, disconnect it from its power source first. Do not clean the switch with any liquid, harsh, chemical-based cleaners, or damp materials.
- Keep the switch away from water and out of damp areas.
- Not intended for submersion in water. Installation in a sheltered location recommended.
- Do not place the switch on unstable surfaces or underneath heavy objects, and avoid dropping the switch.
- Allow for adequate space for ventilation between the device and objects around it.
- Ensure that the operating voltage is the same as labeled in the switch
Installation:
Warning: Install in an area that can support the total weight of the camera and accessories.
Desktop Installation:
Attach the provided rubber feet at each bottom corner of the switch.
Rack Mount Installation:
Your switch can be installed on an EIA-19" (48.26 cm) equipment rack.
- Install the mounting brackets on each of the switch’s side panels using the provided screws.
- Use the provided screws to mount the switch to the rack.
Setup:
