< Back to list

W461ASC - 2K Indoor Wi-Fi Security Camera : Motion Detection Settings

You can enable/disable the following settings from the Motion Detection screen for your 2K Indoor Wi-Fi Security Camera (W462AQC):

  • Motion Detection
  • Person Detection
  • Motion Sensitivity
  • Motion Zones™

To enable/disable Motion/Person Detection

Enabling Motion or Person detection will record video and send notifications when motion or person is detected. Note: Notifications must be enabled.

Motion Detection

  1. Launch the Lorex App.

  2. Tap icon above the channel thumbnail on the Devices screen.

  3. Tap Motion Detection Settings.

  4. Tap icon to enable Motion/Person Detection. Tap again to disable.


To change Motion Sensitivity

You can adjust the level of Motion Sensitivity of your Lorex device according to your preference. The higher the sensitivity level, the less motion is required to trigger an event.

Note: Higher sensitivity will result in increased notifications.

Motion Sensitivity

  1. Launch the Lorex App.

  2. Tap icon above the channel thumbnail on the Devices screen.

  3. Tap Motion Detection Settings.

  4. Tap Motion Sensitivity.

  5. Tap and select the level of Motion Sensitivity, then tap Save.


Configuring Motion Zones™

Motion Zones™ allows you to customize your device’s motion detection region. Areas of the camera image that trigger unwanted motion events can be ignored, such as a busy sidewalk or trees blowing in the wind.

To set Motion Zones™

  1. Launch the Lorex App.

  2. Tap icon above the channel thumbnail on the Devices screen.

  3. Tap Motion Detection Settings.

  4. Tap Motion Zones™.


To set customized Motion Zones™

This setting can only detect motion in the specified area.

By default, the entire area has a blue overlay, meaning that a motion event happening anywhere on the screen will trigger an event.

General Motion Zone

  1. Tapdelete icon to remove the blue overlay from the entire image.

  2. Tap and drag over the area where you want motion detection enabled.
    Note: The deselected area will grey out and the selected area will be highlighted in blue.

Custom

  1. (Optional) Taperase icon to exclude any area from the Motion Zones™.

  2. (Optional) Tapswitch icon switch the Motion Zones™ to the unselected area.

  3. Tap Save.


Rate This Article
Was this article helpful?