E893DD, E893AB, Halo Series, H13 - 4K IP Wired Bullet & Dome Security Cameras with Smart Deterrence: Motion Detection Settings

You can enable/disable the following settings from the Motion Detection screen for your 4K Smart Deterrence IP Cameras (E893DD Series, E893AB Series):

• Motion Detection
• Person Detection
• Vehicle Detection
• Face Detection
• Missing Object Detection
• Abandoned Object Detection
• Motion Sensitivity
• Motion Zones™

To enable/disable Motion/Person/Vehicle detection

Enabling motion, person, and/or vehicle detection will record video and send notifications when motion, person, and/or vehicle is detected.

Note: Notifications must be enabled.

1. Launch the Lorex App.

2. Tap icon above the channel thumbnail on the Devices screen.

3. Tap Motion Detection Settings.

4. Tap icon to enable Motion/Person/Vehicle Detection. Tap again to disable.

To enable/disable Face/Missing Object/Abandoned Object detection

Face/Missing Object/Abandoned Object detection must be setup and configured through the recorder. Enabling these features will disable Person and Vehicle detection.

1. Launch the Lorex App.

2. Tap icon above the channel thumbnail on the Devices screen.

3. Tap Motion Detection Settings.

4. Tap icon to enable Face/Missing Object/Abandoned Object detection. Tap again to disable.

• Face Detection: Receive notifications when a face is detected.

• Missing Object Detection: Set your camera to monitor specific objects and receive notifications when they are detected as missing.

• Abandoned Object Detection: Receive notifications when objects are detected to be left in a preset area.

To change Motion Sensitivity

You can adjust the level of Motion Sensitivity of your Lorex device according to your preference. The higher the sensitivity level, the less motion is required to trigger an event.

Note: Higher sensitivity will result in increased notifications.

1. Launch the Lorex App.

2. Tap icon above the channel thumbnail on the Devices screen.

3. Tap Motion Detection Settings.

4. Tap Motion Sensitivity.

5. Tap and select the level of Motion Sensitivity, then tap Save.

Configuring Motion Zones™

Motion Zones™ allows you to customize your device’s motion detection region. Areas of the camera image that trigger unwanted motion events can be ignored, such as a busy sidewalk or trees blowing in the wind.

To set Motion Zones™

1. Launch the Lorex App.

2. Tap icon above the channel thumbnail on the Devices screen.

3. Tap Motion Detection Settings.

4. Tap Motion Zones™.

To set customized Motion Zones™

This setting can only detect motion in the specified area.

By default, the entire area has a blue overlay, meaning that a motion event happening anywhere on the screen will trigger an event.

1. Tap icon to remove the blue overlay from the entire image.

2. Tap and drag over the area where you want motion detection enabled.
   Note: The deselected area will grey out and the selected area will be highlighted in blue.

3. (Optional) Tap icon to exclude any area from the Motion Zones™.

4. (Optional) Tap icon switch the Motion Zones™ to the unselected area.

5. Tap Save.