E842CA, E842CD, A Series, A14 - 4K IP Wired Bullet & Dome Security Cameras: Installation

This article provides instructions for installing your 4K IP Wired Bullet Security Camera E842CA, E842CD Series.

Table of Contents:

• What's Included
• Camera Placement Tips
• Installation
  • Camera Mounting
  • Camera Connection
  • Weather-Resisitant Cap

What's Included

• 4K Ultra HD Bullet Camera or 4K Ultra HD Dome Camera
• Ethernet Extension Cable
• Mounting Template
• Anchors & Screws (4×)
• Mounting Bracket (included with dome cameras only)

Camera Placement Tips

• Take into consideration what you want to monitor and where is the best coverage area.
• Place your camera close to the area of interest.
• Point the camera where there is the least amount of obstructions (i.e. tree branches)
• Install the camera in a location that is difficult for thieves and vandals to reach.
• The best position is 10 ft (3 m) above ground, angled 15° down.
• Secure cabling so that it is not exposed or easily cut.

Installation

Camera Mounting

Bullet Camera

1. Use the provided Mounting Template to mark holes for screws, then drill holes for the mounting screws.

   Optional: Insert the provided drywall anchors if you are installing the camera in drywall.

2. Feed the cable through the mounting surface or cable notch and mount the camera’s bracket to the surface using the provided screws.

3. Connect cables as seen in Camera Connection.

4. Loosen the adjustment screw and position your camera as needed, then tighten to secure it in place.

5. Remove the vinyl film from the camera lens when your installation is complete.

Dome Camera

1. Use the included Mounting Template to mark hole for screws, then drill holes for the mounting screws.

   Optional: Insert the provided drywall anchors if you are installing the camera in drywall.

2. Using a Phillips-head screwdriver and the provided screws, secure the Mounting Bracket to the surface.

3. Feed the cable through the mounting surface or cable notch and mount the camera’s bracket to the surface using the provided screws.

4. Connect cables as seen in Camera Connection.

5. Press the camera into the Mounting Bracket until you hear a ‘click’.

6. Loosen the adjustment screw and position your camera as needed, then tighten to secure it in place.

7. Remove the vinyl film from the camera lens when your installation is complete.

Camera Connection

Connect your camera directly to your recorder using the camera’s Ethernet extension cable.

Weather-Resistant Cap

Twist the Ethernet extension cable’s pre-attached weather-resistant cap securely onto your camera’s Ethernet connector. If exposed to regular precipitation, seal the cap with silicone and electrical tape.