AX8 Series: 8-Port PoE Switch: Installation Guide

This article gives installation instructions for your [AX8 8-Port PoE Switch]().

What's Included:

• PoE Switch
• Power Cord
• Rubber Feet (4×)
• • Rack Mount Brackets (2×)
• Screws (8×)

Safety Precautions:

• Follow all instructions for safe use and best performance.
• Use the switch within given temperature, humidity and voltage levels noted in the switch specifications.
• Do not disassemble the switch.
• You may need to clean periodically using a cloth. If you need to clean the switch, disconnect it from its power source first. Do not clean the switch with any liquid, harsh, chemical-based cleaners, or damp materials.
• Keep the switch away from water and out of damp areas.
• Not intended for submersion in water. Installation in a sheltered location recommended.
• Do not place the switch on unstable surfaces and avoid dropping the switch.
• Allow for adequate space for ventilation between the device and objects around it.
• Ensure that the operating voltage is the same as labeled in the switch.

Installation:

Warning: Install in an area that can support the total weight of the camera and accessories.

Desktop Installation:

Attach the provided rubber feet at each bottom corner of the switch.

Wall Mount Installation:

1. In your wall, insert two M4 screws (not included) 6” (15.24 cm) apart.
2. Line up the indents on the bottom of your switch with the screws.
3. Place the switch so that the screws are inside of the indents, and carefully lower the switch so that the screws are in locking position.

Rack Mount Installation:

Your switch can be installed on an EIA-19" (48.26 cm) equipment rack.

1. Install the mounting brackets on each of the switch’s side panels using the provided screws.
2. Use the provided screws to mount the switch to the rack.

Setup