Configuration and Setup

Search Articles in this category

LNR Series: Connecting IP cameras through a network

IP cameras can be connected directly to an LNR Series NVR, or connected through the network using a router, or a Power over Ethernet (PoE) switch. To connect IP...

Learn More >

LNR Series: Connecting IP cameras to your NVR

To add an IP Camera to your LNR Series NVR, you must connect the cameras to the same Router and Local Area Network (LAN) as your NVR. You must...

Learn More >

LNR Series: Setting up your NVR

You can set up your LNR Series NVR to be used with a monitor (not included) and wired mouse (included). To set up...

Learn More >

LNR200 / LNR300 Series: Accessing system information

The Device Info window for your LNR200 / LNR300 Series NVR system displays useful system information such as the IP address, MAC address, device ID, Device model, and firmware...

Learn More >

LNR200 / LNR300 Series: Adjusting motion detection settings

By default, motion detection is enabled on all cameras connected to your LNR200 / LNR300 Series NVR. You can enable / disable cameras for motion detection. You can also enable / disable...

Learn More >

LNR200 / LNR300 Series: Changing the IP address of the NVR

When your LNR200 / LNR300 Series NVR system connects to your router it requires an IP address to communicate with. This IP address can either be automatically assigned by the...

Learn More >

LNR200 / LNR300 Series: Configuring display settings

Different monitors can support different image / video resolutions. If your image appears pixelated or cut off, you may need to modify your LNR200 / LNR300 Series NVR display resolution. You can...

Learn More >

LNR200 / LNR300 Series: Configuring Mainstream recording resolution, frame rate, and image quality

You can configure recording and streaming parameters on your LNR200 / LNR300 Series NVR such as the resolution, frame rate, and image quality. The Encoding Settings are set separately for Continuous...

Learn More >

LNR200 / LNR300 Series: Configuring motion detection alarms on your NVR

By default, motion detection is enabled on all connected cameras on your LNR200 / LNR300 Series NVR. You can configure the alarm actions that occur when motion detection is triggered. The...

Learn More >

LNR200 / LNR300 Series: Configuring Pre and Post Recording times

LNR200 / LNR300 Series NVRs support pre- and post-recording. The Pre-record time determines how long the NVR will record before an event (such as motion or video loss) occurs. The Post-record time...

Learn More >

121 - 130 of 210