W461ASC - 2K Indoor Wi-Fi Security Camera : Device Settings

This article provides overview of Device Settings available on the Lorex App. You can configure settings for your 2K Indoor Wi-Fi Security Camera (W461ASC) from anywhere using the Lorex App.

Device Settings Overview

From the Devices screen, tap icon to configure device settings.
Note: Device settings differs between products. Your device settings may not include all the settings from the example below.

1. Basic Information: Tap to change the device password, set device name, change thumbnail photo, or view device ID. For full instructions, see Basic Device Settings.

2. Firmware: Tap to view the current and latest firmware version.

3. Notifications: Enable/disable notifications. For full instructions, see Notification Settings.

4. Motion Detection Settings: Enable/disable motion detection and person/vehicle detection per channel on supporting platforms. For full instructions, see Motion Detection Settings.

5. Sound Detection Settings: Tap icon to record video and send notifications when sound is detected at or above the preset decibel level. For full instructions, see Sound Detection Settings.
   Note: Sound Sensitivity level is 90dB by default.

6. Video Settings: Tap icon to enable HDR (High Dynamic Range).
   Note: Enabling HDR optimizes video picture in high-contrast conditions such as under-lit and over-lit areas.
   By default, the video quality is set to High (2x1080p HD).

7. Device Storage: Tap to view or format your device storage. For full instructions, see Device Storage.

8. Local Storage: Tap to change the streaming quality or enable/disable General Record Storage. For full instructions, see Local Storage.

9. Recording: Tap icon to disable recording. Tap again to enable.

10. Auto Night Vision: Tap icon to disable Auto Night Vision. Tap again to enable.
    Note: Disabling Auto Night Vision will force the camera into color mode. Recommended in low-light conditions.

11. Privacy Mode: Tap icon to enable privacy mode. Tap again to disable.

12. Audio Recording: Enable/disable audio recordings per channel. (audio-enabled cameras required)

13. Shared Users: Tap to send an invitation to another Lorex App account to access the selected device. For full instructions, see Shared Users.

14. Wireless Network: Change the Wi-Fi network that is associated with the camera.

15. Status LED: Tap icon to disable the status LED on the camera. Tap again to enable.

16. Image Rotation: Tap icon to rotate the camera feed 180°.
    Note: Recommended if you are installing the camera upside down.

17. Time Zone: Tap to change the time zone or to configure Daylight Savings Time.

18. Device Info: View the device’s model number, device ID, IP address, and MAC address.

19. Reboot Device: Reboot your Lorex device remotely. Wait a few minutes before connecting to the device after restarting.

20. Remove Device: Remove device from Lorex App.
    Note: Removing your device will not affect recordings or snapshots on your mobile device storage.