2K Pan-Tilt Outdoor Wi-Fi security camera - Device Settings

This article provides overview of Device Settings available on the Lorex App. You can configure settings for your 2K Pan-Tilt Outdoor Wi-Fi security camera (F461AQ) from anywhere using the Lorex App.

Device Settings Overview

From the Devices screen, tap icon to configure device settings.
Note: Device settings differs between products. Your device settings may not include all the settings from the example below.

1. Basic Information: Tap to change the device password, set device name, change thumbnail photo, or view device ID. For full instructions, see Basic Device Settings.

2. Firmware: Tap to view the current and latest firmware version.

3. Notifications: Enable/disable notifications. For full instructions, see Notification Settings.

4. Motion Detection Settings: Enable/disable motion detection and person/vehicle detection per channel on supporting platforms. For full instructions, see Motion Detection Settings.

5. Video Settings: Tap icon to enable HDR (High Dynamic Range).
   Note: Enabling HDR optimizes video picture in high-contrast conditions such as under-lit and over-lit areas.
   By default, the video quality is set to High.

6. Sound Settings: Tap to adjust the Siren or Two-Way Talk volume.

7. Device Storage: Tap to view or format your device storage. For full instructions, see Device Storage.

8. Local Storage: Tap to change the streaming quality or enable/disable General Record Storage. For full instructions, see Local Storage.

9. Recording: Tap icon to disable recording. Tap again to enable.

10. Deterrence Light Brightness:
    

• Tap the icon to enable Deterrence Light on Motion. Note: Motion Detection must be enabled to activate the deterrence light on motion.
• Tap Deterrence Light Mode to select either Solid or Flashing mode for the deterrence light.
• Tap and select the level of Deterrence Light Brightness.
• Tap Save to apply any changes.

11. Siren Settings: Tap the icon to enable Activate Siren on Motion.

12. Auto Night Vision: Tap icon to disable Auto Night Vision. Tap again to enable.
    Note: Disabling Auto Night Vision will force the camera into color mode. Recommended in low-light conditions.

13. Privacy Mode: Tap icon to enable privacy mode. Tap again to disable.

14. Audio Recording: Enable/disable audio recordings per channel. (audio-enabled cameras required)

15. Shared Users: Tap to send an invitation to another Lorex App account to access the selected device. For full instructions, see Shared Users.

16. Wireless Network: Change the Wi-Fi network that is associated with the camera.

17. Status LED: Tap icon to disable the status LED on the camera. Tap again to enable.

18. Image Rotation: Tap icon to rotate the camera feed 180°.
    Note: Recommended if you are installing the camera upside down.

19. Time Zone: Tap to change the time zone or to configure Daylight Savings Time. For full instructions on Time Zone, see Configuring Time Zone.

20. Device Info: View the device’s model number, device ID, IP address, and MAC address.

21. Reboot Device: Reboot your Lorex device remotely. Wait a few minutes before connecting to the device after restarting.

22. Remove Device: Remove device from Lorex App.
    Note: Removing your device will not affect recordings or snapshots on your mobile device storage.